What does fault code P0335 mean?

Crankshaft Position Sensor A Circuit. The ECM is not receiving a valid signal from the crankshaft position sensor.

P0335

Crankshaft Position Sensor A Circuit

Q: What are the possible causes of P0335?

Crankshaft position sensor damaged; Sensor signal wire open or shorted; Excessive gap between sensor and tone wheel; Tone wheel damaged or missing teeth; ECM fault.

Severity: High Ignition System Generic Code

Detailed Description

The ECM is not receiving a valid signal from the crankshaft position sensor.

Possible Causes

Crankshaft position sensor damaged

Sensor signal wire open or shorted

Excessive gap between sensor and tone wheel

Tone wheel damaged or missing teeth

ECM fault.

Solutions & Repair Guide

This is a common cause of no-start conditions. Check sensor installation and gap; Measure sensor coil resistance (typically 800-1200 ohms); Use an oscilloscope to check the sensor output signal waveform; Inspect the tone wheel for damage.

Disclaimer: The information above is for reference only and does not constitute professional repair advice. Actual causes may vary depending on vehicle make, model, year, and configuration. Always consult a qualified technician for accurate diagnosis.